Caterpillar Part reference

1140489bolt; (m5x0.8x75-mm)

This page covers the Caterpillar bolt listed under part number 1140489, described in the catalog as a bolt with an M5 x 0.8 x 75 mm designation. The catalog associates this part with hydraulic system solenoid valve group entries for the Caterpillar 3054C, but these are catalog occurrences only and should be confirmed against the recorded conditions before use.

Recorded applications

Models and catalog references

Selected catalog references that list this part. A catalog association does not confirm fitment for every machine or configuration.

  • Caterpillar 3054C
  • Caterpillar 3054E
  • Caterpillar 3066
& More catalog references

Catalog context

Where this part appears

  1. ModelCaterpillar 3054C
    Browse Caterpillar models
  2. Grouphydraulic system
  3. Subgroupvalve group-solenoid
  4. Unit185-0507 valve gp-solenoid s/n anf1-up part of 204-8416 lines gp-pilot an attachment
Reduced catalog diagram for Caterpillar 3054C Locked
Diagram previewReduced catalog thumbnail
About diagram access

Check the signed-in Part Book for available diagrams and the complete catalog breakdown.

Parts in this preview

Selected records
Selected catalog parts, with other part numbers masked
Part numberDescription
08***38seal-o-ring
10***40collar
10***41ring; (retaining)
1140489bolt; (m5x0.8x75-mm) (current part)

Selected entries from this catalog unit. Other part numbers are masked. Confirm the full breakdown and your machine configuration before ordering.

Browse Caterpillar models

General guidance

Component knowledge

Understanding this component

In general, a bolt is a threaded externally threaded fastener used to clamp or secure parts together, usually with a nut or a threaded hole. The metric designation in the catalog description identifies the thread and length as recorded, and the exact application depends on the assembly where it is used.

What to check before ordering

Order using the existing part number 1140489 as listed in the catalog. Before ordering, check the catalog occurrences and any recorded conditions for the machine and assembly you are working on, since a listing association does not establish compatibility for every configuration.