Caterpillar Part reference

1055096resistor

Caterpillar part number 1055096 is listed in the catalog as a resistor. In the catalog, this target part is associated with the operator station instrument panel group for the AP-800C and AP-800D models, as shown in the catalog occurrences below. Confirm the recorded conditions of each association before ordering.

Recorded applications

Models and catalog references

Selected catalog references that list this part. A catalog association does not confirm fitment for every machine or configuration.

& More catalog references

Catalog context

Where this part appears

  1. ModelCaterpillar AP-800C
  2. Groupoperator station
  3. Subgrouppanel group-instrument
  4. Unit219-3004 panel gp-instrument s/n 9al280-up; 1pm768-up part of 104-6585 installation gp-controls
Reduced catalog diagram for Caterpillar AP-800C Locked
Diagram previewReduced catalog thumbnail
About diagram access

Check the signed-in Part Book for available diagrams and the complete catalog breakdown.

Parts in this preview

Selected records
Selected catalog parts, with other part numbers masked
Part numberDescription
07***00switch as-toggle; (starter engine battery charger)
10***03kit; (receptacle) (3-pin) (includes receptacle as & wedge)
10***04kit-receptacle; (4-pin)(start switch)
1055096resistor (current part)

Selected entries from this catalog unit. Other part numbers are masked. Confirm the full breakdown and your machine configuration before ordering.

View model page

General guidance

Component knowledge

Understanding this component

In general, a resistor is an electrical component that limits current flow or sets a voltage level within a circuit. In heavy equipment, resistors are commonly used in instrument and control circuits to protect components, condition signals, or provide defined electrical values.

What to check before ordering

Use part number 1055096 when referencing this resistor in the catalog. Before ordering, check the catalog occurrences for the instrument panel association and confirm that the recorded serial number and configuration conditions match your machine.