Caterpillar Part reference

0775031stud

Caterpillar part number 0775031, catalogued as a stud. The catalog records this item in association with planetary group final drive assemblies within the power train group for the Caterpillar AP-1000 model, but these entries describe catalog context only and do not confirm fitment on every machine or configuration. Confirm the recorded conditions before ordering.

Recorded applications

Models and catalog references

Selected catalog references that list this part. A catalog association does not confirm fitment for every machine or configuration.

& More catalog references

Catalog context

Where this part appears

  1. ModelCaterpillar AP-1000
  2. Grouppower train
  3. Subgroupplanetary group-final drive
  4. Unit111-3451 planetary gp-final drive s/n 1hd98-up part of 111-1333 drive gp-rear
Reduced catalog diagram for Caterpillar AP-1000 Locked
Diagram previewReduced catalog thumbnail
About diagram access

Check the signed-in Part Book for available diagrams and the complete catalog breakdown.

Parts in this preview

Selected records
Selected catalog parts, with other part numbers masked
Part numberDescription
06***11thrust race; (pa110b-245), seal
07***78seal-o-ring
0775031stud (current part)
08***62gear-planetary; (34-teeth)

Selected entries from this catalog unit. Other part numbers are masked. Confirm the full breakdown and your machine configuration before ordering.

View model page

General guidance

Component knowledge

Understanding this component

In general, a stud is a threaded fastener, usually a rod threaded at one or both ends, that is secured into a component and used with a nut or mating threaded part to clamp or position parts together. In heavy equipment, studs are commonly used on final drives, wheel hubs and similar assemblies where a secure, repeatable joint is needed.

What to check before ordering

Order using part number 0775031 as shown in the catalog. Before purchasing, check that the recorded catalog associations and their listed conditions match your machine and the assembly you are servicing, since the catalog association alone does not establish compatibility.