Caterpillar Part reference

1110897cone-bearing

Cone-bearing 1110897 is listed in the Caterpillar catalog as a bearing part. The catalog records two occurrences inside larger power train assemblies on Caterpillar 854G and 992K entries, but these are catalog associations only and do not establish fitment on every machine configuration.

Recorded applications

Models and catalog references

Selected catalog references that list this part. A catalog association does not confirm fitment for every machine or configuration.

Catalog context

Where this part appears

  1. ModelCaterpillar 854G
  2. Grouppower train
  3. Subgroupvalve group-selector & press cont
  4. Unit117-5860 valve gp-selector & press cont -transmission s/n 9bx1349-up part of 117-5859 valve gp-transmission control
Reduced catalog diagram for Caterpillar 854G Locked
Diagram previewReduced catalog thumbnail
About diagram access

Check the signed-in Part Book for available diagrams and the complete catalog breakdown.

Parts in this preview

Selected records
Selected catalog parts, with other part numbers masked
Part numberDescription
03***57bolt; --to reverse shaft bearing retainer & forward shaft bearing retainer
03***60bolt-self locking; (5/16-18x1.0)
10***89gear-ring; (87-teeth)
1110897cone-bearing (current part)

Selected entries from this catalog unit. Other part numbers are masked. Confirm the full breakdown and your machine configuration before ordering.

View model page

General guidance

Component knowledge

Understanding this component

In general, a cone bearing is a tapered roller bearing made of an inner cone that carries rollers and an outer cup that they run against, allowing it to take both radial and axial loads. Bearings of this type are used in heavy-equipment drivetrains where rotating shafts must be supported under load and kept properly aligned.

What to check before ordering

Reference part number 1110897 when inquiring about this bearing. Before ordering, confirm the recorded catalog conditions for the machine model, serial number and assembly location, since the listed occurrences are only catalog associations and do not confirm compatibility for every configuration.