Caterpillar Part reference

1100160washer-thrust; (2.7mm(.106in)thk)

Thrust washer, catalog number 1100160, listed by Caterpillar with a recorded thickness of 2.7mm (.106in). It is cataloged in the power train group as a thrust washer, and it appears in two catalog associations with axle assemblies on other Caterpillar units. Confirm any association against your machine's recorded conditions before relying on it.

Recorded applications

Models and catalog references

Selected catalog references that list this part. A catalog association does not confirm fitment for every machine or configuration.

& More catalog references

Catalog context

Where this part appears

  1. ModelCaterpillar 426C
  2. Grouppower train
  3. Subgroupaxle group-drive & steering
  4. Unit111-1523 axle gp-drive & steering -rear s/n 1mr1-955 ratio 18.62. all wheel steer part of 112-2113 axle & mtg gp-drive & steering an attachment
Reduced catalog diagram for Caterpillar 426C Locked
Diagram previewReduced catalog thumbnail
About diagram access

Check the signed-in Part Book for available diagrams and the complete catalog breakdown.

Parts in this preview

Selected records
Selected catalog parts, with other part numbers masked
Part numberDescription
00***02cone-roller bearing
00***18housing-axle drive
00***19cone-roller bearing
1100160washer-thrust; (2.7mm(.106in)thk) (current part)

Selected entries from this catalog unit. Other part numbers are masked. Confirm the full breakdown and your machine configuration before ordering.

View model page

General guidance

Component knowledge

Understanding this component

In general, a thrust washer is a flat bearing ring placed between rotating and stationary or adjacent parts to take up axial (end-to-end) load and limit movement along a shaft. Its thickness is often used to set end play or clearance, so the recorded dimension should be matched carefully when identifying a replacement.

What to check before ordering

Use part number 1100160 as the reference for this listing. Compare the recorded 2.7mm (.106in) thickness and the catalog associations with your machine's serial and configuration details before ordering, since catalog associations do not establish compatibility for every configuration.