Caterpillar Part reference

1074728pipe-extension

This catalog page covers Caterpillar part number 1074728, listed as a pipe-extension. The catalog associates it with air inlet and exhaust system assemblies for Caterpillar 914G and 930G machines, shown as catalog occurrences rather than confirmed fitment for every configuration.

Recorded applications

Models and catalog references

Selected catalog references that list this part. A catalog association does not confirm fitment for every machine or configuration.

Catalog context

Where this part appears

  1. ModelCaterpillar 914G
  2. Groupair inlet and exhaust system
  3. Subgroupextension group-exhaust
  4. Unit113-1514 extension gp-exhaust -short s/n 7zm1-439; 9wm1-1012 part of 117-9835, 117-9836 operator ar-enclosed rops, 132-1362 platform ar
Reduced catalog diagram for Caterpillar 914G Locked
Diagram previewReduced catalog thumbnail
About diagram access

Check the signed-in Part Book for available diagrams and the complete catalog breakdown.

Parts in this preview

Selected records
Selected catalog parts, with other part numbers masked
Part numberDescription
1074728pipe-extension (current part)
11***14extension group-exhaust; -short
7N***10clamp
8T***21washer-hard; (11x21x2.5-mm thk)(m10x1.50x30mm)

Selected entries from this catalog unit. Other part numbers are masked. Confirm the full breakdown and your machine configuration before ordering.

View model page

General guidance

Component knowledge

Understanding this component

In general, a pipe extension is a tubular section added to lengthen an existing air inlet or exhaust pipe run, helping route air or exhaust gas to the correct location on a machine. Exact dimensions, materials and any supplied contents are not stated in the catalog data for this part, so they should be confirmed before ordering.

What to check before ordering

Use part number 1074728 as the reference when requesting this item. Before ordering, compare the catalog occurrences shown on this page with your machine's model, serial number and configuration, since the recorded conditions for the parent assemblies are not automatically applicable to this part.