Caterpillar Part reference

1061094edge-cutting-lh

Part 1061094 is listed in the catalog as an edge-cutting-lh item, a left-hand edge-cutting component. Catalog occurrences associate it with edge-cutting groups for Caterpillar 988G and 988H wheel loader work tool assemblies, but these are catalog associations only and should be confirmed against the recorded conditions before ordering.

Recorded applications

Models and catalog references

Selected catalog references that list this part. A catalog association does not confirm fitment for every machine or configuration.

Catalog context

Where this part appears

  1. ModelCaterpillar 988G
  2. Groupwork tools
  3. Subgroupedge group-cutting
  4. Unit208-8840 edge gp-cutting s/n 2tw1-up for use with wheel loader rock buckets an attachment
Model photo of Caterpillar 988GModel photo
Model photoCaterpillar 988G
About diagram access

Check the signed-in Part Book for available diagrams and the complete catalog breakdown.

Parts in this preview

Selected records
Selected catalog parts, with other part numbers masked
Part numberDescription
1061094edge-cutting-lh (current part)
10***95edge-cutting-lh
10***96edge-cutting
10***97edge-cutting-rh

Selected entries from this catalog unit. Other part numbers are masked. Confirm the full breakdown and your machine configuration before ordering.

View model page

General guidance

Component knowledge

Understanding this component

In general, an edge-cutting component is a wear part fitted to the leading lower edge of a loader bucket or similar work tool to protect the bucket and help it cut and penetrate material. A left-hand designation indicates the part is intended for the left side of the work tool, so the side should be confirmed when comparing catalog entries.

What to check before ordering

Use part number 1061094 as the reference for this listing. Before ordering, check the machine model, serial number range, and attachment configuration against the catalog occurrences for the edge-cutting group, since listed serial and configuration conditions can differ between assemblies.