Caterpillar Part reference

1090238lines group-angle & tilt

Part 1090238 is cataloged as Caterpillar lines group-angle & tilt, a hydraulic line grouping listed in the catalog under the hydraulic system for the angle and tilt function. Catalog occurrences associate this number with D5M bulldozer angle and tilt attachment assemblies. Confirm the recorded serial and attachment conditions before relying on any association.

Recorded applications

Models and catalog references

Selected catalog references that list this part. A catalog association does not confirm fitment for every machine or configuration.

Catalog context

Where this part appears

  1. ModelCaterpillar D5M
  2. Grouphydraulic system
  3. Subgrouplines group-angle & tilt
  4. Unit109-0238 lines gp-angle & tilt s/n 4fp1-up part of 107-6810, 133-9151 bulldozer ar-pwr angle & tilt type 1 an attachment
Reduced catalog diagram for Caterpillar D5M Locked
Diagram previewReduced catalog thumbnail
About diagram access

Check the signed-in Part Book for available diagrams and the complete catalog breakdown.

Parts in this preview

Selected records
Selected catalog parts, with other part numbers masked
Part numberDescription
10***72guard
1090238lines group-angle & tilt (current part)
11***10hose assem.
11***11hose assem.

Selected entries from this catalog unit. Other part numbers are masked. Confirm the full breakdown and your machine configuration before ordering.

View model page

General guidance

Component knowledge

Understanding this component

In general, a hydraulic lines group is a set of pressurized fluid tubes or hoses that carry hydraulic oil between pumps, valves and cylinders on a machine. In an angle and tilt circuit, these lines route oil to the cylinders that adjust the blade position. The exact pieces included in this grouping are not stated in the supplied catalog data.

What to check before ordering

Use part number 1090238 as the catalog reference for this lines group. Before ordering, check the recorded serial number range, attachment type and machine model against your equipment, since catalog associations do not establish fitment for every configuration.