Caterpillar Part reference

1088660lines group-front

Part 1088660, catalogued as lines group-front, appears in the Caterpillar catalog within the hydraulic system group and control arm-auxiliary subgroup. It is associated with the Caterpillar 330 in catalog occurrences, which are listed as catalog associations rather than confirmed fitment for every machine configuration.

Recorded applications

Models and catalog references

Selected catalog references that list this part. A catalog association does not confirm fitment for every machine or configuration.

Catalog context

Where this part appears

  1. ModelCaterpillar 330
  2. Grouphydraulic system
  3. Subgroupcontrol ar-auxiliary
  4. Unit1088670 control ar-auxiliary replace by 1180332 control ar-auxiliary both actions/both flows an attachment
Model photo of Caterpillar 330Model photo
Model photoCaterpillar 330
About diagram access

Check the signed-in Part Book for available diagrams and the complete catalog breakdown.

Parts in this preview

Selected records
Selected catalog parts, with other part numbers masked
Part numberDescription
08***23lines group-pilot
08***24lines group-pilot
10***66film-instruction; (hydraulic hammer)
1088660lines group-front (current part)

Selected entries from this catalog unit. Other part numbers are masked. Confirm the full breakdown and your machine configuration before ordering.

View model page

General guidance

Component knowledge

Understanding this component

In general, a hydraulic lines group is a set of hoses or tubes that carries pressurized hydraulic fluid between pumps, valves and actuators on heavy equipment. A front lines group refers to the lines serving the front section of a machine or attachment, and the exact pieces it includes should be confirmed in the catalog.

What to check before ordering

When ordering, use part number 1088660 exactly as listed. Before purchasing, check the recorded catalog conditions and the machine's serial number, configuration and attachment details against the relevant catalog entry to confirm the lines group applies to your unit.