Caterpillar Part reference

1066421edge-cutting; (rh)

Part number 1066421 is listed in the Caterpillar catalog as an edge-cutting component, specified as right-hand (RH). The catalog records it within the work tools group, under a bucket assembly for the Caterpillar 990H, and this association is a catalog occurrence only. Confirm the recorded conditions before ordering.

Recorded applications

Models and catalog references

Selected catalog references that list this part. A catalog association does not confirm fitment for every machine or configuration.

Catalog context

Where this part appears

  1. ModelCaterpillar 990H
  2. Groupwork tools
  3. Subgroupbucket as-rock
  4. Unit283-1881 bucket as-rock s/n bwx1-up 8.6-cu m (11.2-cu yd) part of 283-1880 bucket gp-rock an attachment
Model photo of Caterpillar 990HModel photo
Model photoCaterpillar 990H
About diagram access

Check the signed-in Part Book for available diagrams and the complete catalog breakdown.

Parts in this preview

Selected records
Selected catalog parts, with other part numbers masked
Part numberDescription
10***20edge-cutting; (center)
1066421edge-cutting; (rh) (current part)
10***23edge-cutting; (lh)
16***96edge-cutting; (lh)

Selected entries from this catalog unit. Other part numbers are masked. Confirm the full breakdown and your machine configuration before ordering.

View model page

General guidance

Component knowledge

Understanding this component

In general, an edge-cutting component is a wear part mounted at the front lower edge of an excavator or loader bucket, where it penetrates and loosens material. Left-hand (LH) and right-hand (RH) designations indicate the side of the bucket on which a piece is positioned, so the orientation must match the bucket layout.

What to check before ordering

Order using the existing target part number 1066421, which is the number displayed for this page. Before ordering, check the recorded catalog conditions for the bucket association and confirm the right-hand orientation and quantity required for your bucket configuration.