Caterpillar Part reference

1030174bracket

Catalog entry 1030174 is a bracket listed under Caterpillar. Its catalog occurrences appear within the electrical and starting system (transformer group-current) and operator station (gauge group) assemblies for Caterpillar 3508C and 3512 models. These are catalog associations only; confirm the recorded conditions before relying on any of them.

Recorded applications

Models and catalog references

Selected catalog references that list this part. A catalog association does not confirm fitment for every machine or configuration.

  • Caterpillar 3508C
  • Caterpillar 3512

Catalog context

Where this part appears

  1. ModelCaterpillar 3508C
    Browse Caterpillar models
  2. Groupelectrical and starting system
  3. Subgrouptransformer group-current
  4. Unit206-0246 transformer gp-current s/n ptk1-up 3500 : 5 ratio for use with emcp ii+ an attachment
Reduced catalog diagram for Caterpillar 3508C Locked
Diagram previewReduced catalog thumbnail
About diagram access

Check the signed-in Part Book for available diagrams and the complete catalog breakdown.

Parts in this preview

Selected records
Selected catalog parts, with other part numbers masked
Part numberDescription
06***95elbow (between fuel lines)
0S***94bolt (1 in. long 3/8 in. dia.); plate assembly to support assembly
0S***15bolt 19 mm (.75 in.) long return air console to enclosed rops
1030174bracket (current part)

Selected entries from this catalog unit. Other part numbers are masked. Confirm the full breakdown and your machine configuration before ordering.

Browse Caterpillar models

General guidance

Component knowledge

Understanding this component

In general, a bracket is a fixed support or mounting piece used to hold, position or secure another component on a machine. Its exact design and the parts it carries depend on the catalog entry and the assembly it belongs to.

What to check before ordering

Use part number 1030174 as the reference for this bracket. Before ordering, check the catalog associations shown for this page and confirm that the recorded model, group and subgroup conditions match your machine and the assembly where the bracket is used.