Jcb FASTRAC 185Ti

Monitor engine oil pressure and coolant temperature gauges daily. Check the air cleaner restriction indicator before each shift; replace the pre-cleaner element at 1,000-hour intervals. Inspect the hydraulic oil filter for metal particles. Use JCB-approved hydraulic oil and engine oil meeting specific viscosity grades. Check the coolant concentration annually to prevent corrosion in the Cummins 6 BTA engine. Inspect the drive shaft universal joints for wear and proper lubrication.

Address hydraulic leaks at the front lift ram seals and control valve O-rings. Replace worn clutch friction plates in the synchromesh transmission if engagement becomes difficult. Inspect the pneumatic dry disc brakes for wear and adjust pedal free play as needed. Check the turbocharger shaft play for excessive movement. Replace the fuel filter if the engine exhibits hard starting or loss of power. Inspect the electrical wiring for chafing near the battery and alternator.

Overhaul the engine at 10,000 hours or when compression drops below specification. Replace the injector nozzles and valve seats if smoke increases or power decreases. Rebuild the transmission if gear slippage occurs or if the electro-hydraulic power shift fails to engage. Inspect the front and rear axle hubs for bearing wear and seal leaks. Replace the PTO shaft bearings and seals if noise or vibration is detected. Check the cab suspension mounts for wear.

In cold weather, use the correct grade of engine oil and ensure the coolant concentration is adequate. Check the battery charge and clean the terminals. Inspect the tire pressure and condition for road use. In dusty environments, check the air cleaner more frequently and replace the element as needed. Clean the radiator and intercoer fins to prevent overheating. Lubricate the front and rear axle pivot points and the steering linkage. Store the machine in a dry place to prevent corrosion.