Jcb FASTRAC 130t-30

Monitor engine oil for soot and fuel dilution every 250 hours. Perkins 6L engines require strict oil change intervals to prevent bearing wear. Sample hydraulic oil at 500 hours to detect pump wear. Check coolant pH levels annually to prevent corrosion in the aluminum cylinder head. Inspect transmission oil for metal particles during the 1000-hour service. Use JCB Super Multigrade 15W/40 oil for standard climates. Low viscosity 10W/30 oil is permitted only for cold starts below -5°C.

Replace fuel filter elements every 250 hours to protect the mechanical injection pump. Inspect the dry clutch assembly for wear if gear shifts become difficult. Check the hydrostatic steering pump for leaks and pressure loss. Replace worn brake pads on the external disc brakes. Inspect the front axle differential for noise or oil leaks. Tighten wheel nuts to specification after the first 50 hours of operation. Replace cracked drive belts during the 250-hour service.

Rebuild the injection pump at 10,000 hours or upon fuel delivery irregularities. Inspect the turbocharger shaft play at 500-hour intervals. Replace the main clutch pack in the gearbox if slippage occurs. Overhaul the front and rear axle epicyclic reductions if oil contamination persists. Inspect the hydrostatic steering motor for internal leakage. Check the suspension hydro-pneumatic accumulators for nitrogen pressure loss. Replace worn bushings in the three-point hitch linkage.

Switch to 10W/30 oil for temperatures below -5°C. Drain the fuel filter bowl daily in wet conditions. Inspect the cooling system for blockage from chaff or dust. Grease all axle pivot points weekly in dusty environments. Check the air filter restriction indicator frequently in high-dust areas. Inspect the cab seals for leaks before winter. Verify the operation of the heater and defroster systems. Check tire pressure changes with temperature fluctuations.